When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This is a replacement nose + connector piece for the Tigger that is 35 inches from Santa’s Best.
This is a 3d printed design created and printed by our family. The 2nd & 3rd picture shows an original nose beside the 3d printed design. You will only receive one 3d printed nose + connector version per purchase. The original is shown for comparison only.
This is a more solid piece, and we have made the connector fit much tighter to the nose so there is less likely breakage or loss. It is a 2 part system, but we have already installed the connector to the nose.
Blow mold is shown for reference only.We size as accurately as possible with pin type push thru parts making several sets until we are happy with the results, but your blow mold may be slightly smaller or larger due to difference in wear. You may need to add a small amount of glue to hold in place or sand or drill a tiny bit to make fit if too tight (do not force).
